Mallinckrodt NPB-190 Manual del operador descargar pdf (Pagina 20)

Quick Guide to Operation

3. Select a Nellcor sensor that is appropriate for the patient

being monitored.

4. Attach the sensor to the patient, following the instructions in

the sensor directions for use.

WARNING: Do not use an extension cable with the NPB-290

monitor (other than the MC-10 or SCP-10 sensor cable). Use

of another sensor extension cable will have an adverse effect

on performance. Do not attach to the sensor port any cable

that is intended for computer use.

5. Connect the sensor to the end of the MC-10 or SCP-10 cable

that has the clear plastic sensor lock. Secure the sensor in

place by lowering the sensor lock over the sensor connector.

Gently press on the sensor lock until it clicks into place.

6. Connect the other end of the MC-10 or SCP-10 cable into the

NPB-290 by gently pushing it straight into the sensor port

located on the front of the monitor.

7. Ensure that nothing is placed in front of the monitor’s speaker

that could interfere with the audible alarm being heard.

Using the Monitor

1. Turn on the NPB-290 by pressing the Power On/Off button.

The monitor conducts a power-on self-test (POST) and

signals successful completion of the test with a 1-second

tone.

WARNING: If you do not hear the POST pass tone, do not

use the monitor.

1. During POST, check to see that all display indicators and

segments light, then listen for the completion tone. This tone

not only indicates the successful completion of POST, it also

confirms that the audible alarm is functional.

2. The Pulse Search indicator lights, and the monitor displays

zeroes while it searches for a valid pulse. If no sensor is

attached, dashes are displayed and the Pulse Search indicator

is not lit.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 78 79

Sin comentarios

Mallinckrodt NPB-190 Manual del operador Pagina 20