Mallinckrodt NPB-190 Manual del operador descargar pdf (Pagina 19)

QUICK GUIDE TO OPERATION

Basic Operation

Alarm Functions

This Quick Guide to Operation section is intended for use by

experienced NPB-290 users. First-time users of this instrument

should read the entire manual before use.

BASIC OPERATION

The NPB-290 operates on AC power when the hospital-grade

power cord is connected to both the monitor and an AC power

source (wall outlet).

The monitor will not operate when its internal battery is

discharged, even when the monitor is connected to AC power.

Since the battery may become discharged during prolonged

storage or shipment, it is important to plug the NPB-290 into an

AC wall outlet and allow the battery to charge for a few minutes

before attempting to turn on the instrument.

Setup

1. With the monitor on a flat, stable surface, plug the female

connector end of the hospital-grade power cord into the rear

of the monitor.

Note: The supply voltage selector switch allows connection of

the monitor to AC power ranging from 100 VAC to 240

VAC. The switch has two positions: one for the 100-120

VAC (“115”), and one for 200-240 VAC (“230”).

Ensure that the supply voltage selector switch on the rear

panel is set to the proper voltage.

2. Verify that the supply voltage selector switch is in the correct

position for your location (see note above). Plug the male

connector end of the power cord into a properly grounded

AC outlet.

WARNING: In the USA, do not connect the monitor to an

electrical outlet controlled by a wall switch.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 78 79

Sin comentarios

Mallinckrodt NPB-190 Manual del operador Pagina 19