Mallinckrodt NPB-190 Manual del operador descargar pdf (Pagina 98)

Data Port Protocol

Note: Selections for Agilent, SpaceLabs, GE Marquette, and

Datex are included in N-395 software versions 1.7 and

higher.

The protocol settings allow the N-395 to communicate with

various devices. ASCII is used during normal operation and for

serial printers. GRAPH is used for graphical trend printouts

when connected to a serial printer that supports Epson ESC

protocol. Select OXINET when connecting to an Oxinet

central station network or Score software. The Bedside Monitor

Interface selections are AGILENT (for Agilent HP monitors),

SPACELBS (for SpaceLab monitors), MARQ (for Marquette

monitors), and DATEX (for Datex-Ohmeda AS/3 monitors). Do

not use the CLINICAL setting unless instructed to do so by

Mallinckrodt’s Technical Services personnel.

REAL-TIME DISPLAY FORMAT

While the N-395 data port protocol setting is set to ASCII (refer

to Start-Up and Use section), real-time data is continuously sent

to the data port on the back of the N-395. Patient data can be

obtained through the data port by connecting it to an attached PC

or serial printer. When a real-time printout or display is being

transmitted to a printer or PC, a new line of data is displayed

every 4 seconds. Column headings will be displayed or printed

after every 25 lines, or if one of the values in the column heading

changes.

Note: If the data output stops transmitting, turn the power off

and back on again or, if connected to a PC, send an XON

(Ctrl-q) to reset the monitor.

An example of a real-time printout is shown in Figure 23.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 109 110

Sin comentarios

Mallinckrodt NPB-190 Manual del operador Pagina 98