Mallinckrodt NPB-190 Manual del operador descargar pdf (Pagina 37)

Start-Up and Use

3. During the POST, the entire display lights and then the

Nellcor brand with model number and software version are

displayed for approximately 3 seconds. All indicator lights

illuminate briefly.

Caution: If any indicator or display element does not light,

do not use the monitor. Instead, contact qualified service

personnel, your local Mallinckrodt representative, or the

Mallinckrodt Technical Services Department.

4. If the N-395 detects an internal problem during POST, an

error code or error message may be displayed and a low

priority alarm will sound. Depending on the reason for the

failure, the screen may be blank or the low priority alarm

may not sound. Refer to the Troubleshooting section for a

list of correctable error messages.

5. Upon successful completion of the POST, the N-395 sounds

a 1-second tone indicating that the monitor has passed the

test.

WARNING: If you do not hear the POST pass tone, do not

use the monitor.

6. If a sensor is connected to the monitor and the patient, the

Pulse Search Indicator lights and the N-395 displays zeroes

in the %SpO

2 and Pulse Rate Displays while it searches for

a valid pulse. If a sensor is not attached to the monitor,

dashes are displayed and the Pulse Search Indicator is not

lit.

When a valid pulse is detected, the N-395 enters the

Monitoring Mode and a display similar to the one indicated

in either Figure 9 or Figure 10 is displayed.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 109 110

Sin comentarios

Mallinckrodt NPB-190 Manual del operador Pagina 37